Depending on your local network, you may need to set your PAX device to use either DHCP LAN mode or Static LAN mode.
Dynamic Host Configuration Protocol (DHCP) - This is a network standard used to automate the process of configuring devices on IP networks. Internet-enabled devices connected to your home or work network are automatically assigned an IP address by your router. Since this is a dynamic assignment, it may change if the router or device is restarted.
Static IP - This setting allows your device to accept an assigned IP address, however, the address is kept until you cancel the IP reservation or remove the device from your network. This is helpful to ensure that your device will remember the same IP address, in the event the router or device is restarted.
- Integrated Payments: Connectivity Troubleshooting Resources
- Integrated Payment Devices: Find the IP Address Assigned to Your Bluefin PAX A80
- Integrated Payment Devices: Ping Your Device to See if it is Reachable
- Integrated Payment Devices: Updating Your IP Address in RepairQ
Note: You will need your IP address if you are changing your LAN type to Static.
Changing to DHCP to Receive a New IP Address (WiFi)
1. On your PAX A80, exit the Bluefin Application by pressing the red Cancel Key. When prompted to exit, tap OK (or press the green Enter key).
2. On the home screen, tap the Settings icon.
3. On the Password screen, enter your password and then tap the Checkmark Icon. Then tap OK.
Alternatively, you can enter your password and press the green Enter key twice.
Note: The default password for a Bluefin PAX A80 is "9876" or "pax9876@@". If you need to reset your password, you will need to contact Bluefin Support.
4. On the Settings page, locate the Wireless & networks section. Under this section, tap Wi-Fi.
5. On the Wi-Fi screen, press and hold the name of your active network connection. Additional settings will appear. Tap Modify network.
6. On the network settings page, tap the Dropdown Arrow next to Advanced Options. Scroll down to the IP Settings section.
7. Next to the IP Settings section, tap the Dropdown Arrow arrow and select DHCP.
8. Tap Save to submit your changes.
10. Power-cycle your device by pressing and holding the red Cancel/Power button. Then tap Reboot and OK.
Changing to Static Mode to Save Your IP Address (WiFi)
If the IP address assigned to your PAX device changes, you will need to update the IP address in your RepairQ Payment Device settings before RepairQ will be able to communicate with the device again. To prevent this from happening, you can set up the device to use a static IP.
1. You can follow the above steps (1-6) until you are in the IP Settings section.
2. Next to the IP Settings section, tap the Dropdown Arrow and select Static.
3. Enter your current IP address and tap Save.
4. Tap the Home button to go back to the home screen.